Farmall & IHC Tractors Discussion Board |
Re: question for allan
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by pcy1066 on December 08, 2006 at 07:30:13 from (209.143.36.23):
In Reply to: Re: question for allan posted by meanmoline on December 08, 2006 at 07:15:07:
it can b the cross or a bearing, or even the backlash setn up to tight, on a9 or 1066 ih if one tire spins more than the other it dont take long to burn up the cross the sun gears will actually cut the cross in to then the tractor wont move, sometimes the sun gears will gauld to the cross and the tractor will only go strait act like its got posi taractionm and when the cross is worn they will make all kindsa funny noises, im no expert just a farmer ,tractor puller who works on these old tractors for a hobby and to try and keep the wolf away from the door, the last 705 mm we did i drilled a hole thruthe side of the case and [ut a snubber bolt on the ring gear to keep it from walkin, sorry for the typin errers, thanks to diabetees i dont see so good and i dont hit the keeys im lookin at thanks paul
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|