Farmall & IHC Tractors Discussion Board |
756 overhaul
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Alex in Texas on December 04, 2006 at 13:01:55 from (158.135.1.91):
I am in the process of overhauling a 756 with German 310 diesel. I originally planned on doing an inframe overhaul, but had to split the tractor to get to rear (#7) main bearing. The tractor ran great, but was getting coolant in the oil due to (I think) deteriorated sleeve packings. My question is: Should I suck it up and go ahead and pull the engine and do a major overhaul since it is already split? The tractor has no problems other than the coolant in oil. But is there a good chance that the cam bushings were trashed by the antifreeze? The engine has 5,400 hours on it. Thanks guys for any suggestions or info.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|