Farmall & IHC Tractors Discussion Board |
Re: Which 3-point hitches will work on my M?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rustyfarmall on December 03, 2006 at 13:30:52 from (207.32.13.209):
In Reply to: Which 3-point hitches will work on my M? posted by Blue3992 on December 03, 2006 at 11:54:59:
The M was never offered with a 2 point or 3 point hitch. A 2 point hitch would be very difficult if not impossible to adapt. 3 point aftermarket hitches are available for your M that can be attached fairly easily, and are still available brand new. I think this site may have new 3 point hitches available, and several other dealers have them also. Check out the prices on the new units before you pay too much for a pile of junk on ebay. Also, the add on 3 point hitches do not work as well as the 3 point on a tractor that was factory equipped. Depending on what the 3 point will be used for, you might be better off to trade the M for a newer tractor with a factory 3 point.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|