Farmall & IHC Tractors Discussion Board |
Re: case loader on 784.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on November 30, 2006 at 11:04:22 from (64.80.108.52):
In Reply to: Re: case loader on 784. posted by Colleen R. Franke on November 30, 2006 at 10:45:50:
"Crack a line" is a slang term for loosening one of the connections to see if hydraulic oil is present in the line. This is VERY dangerous to do with the hydraulic system under pressure. Hydraulic oil freezes at several hundred degrees below zero. No, it could not have frozen up unless there is a lot of water in the hydraulic oil, and then it wouldn't have frozen up in the middle of a job. The most likely cause of your problem is a bad hydraulic pump. They usually get weaker and weaker over time, but it's not unheard of to have the pump simply quit altogether. I am pretty sure that the power steering and 3pt hitch are controlled by a separate hydraulic pump on that tractor. The best thing you can do right now is hire a professional mechanic to come over and check your hydraulic system for pressure, and have it "flow rated." Otherwise, you are just guessing.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|