|
Farmall Tractors Discussion Board |
Re: cub hand crank dimensions
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Farmer Bob on January 31, 2000 at 21:23:42 from (207.227.187.91):
In Reply to: cub hand crank dimensions posted by Gary on January 31, 2000 at 15:19:59:
Gary, I just made my Cub crank using 5/8" round stock. Starting with the end you hang on to:
4-1/2" to first 90 degree bend, then 8-1/2" to second 90 degree bend, then 13-3/4" to the business end of the crank. Back-up 3/4" from the business end and drill a 5/16" hole through the crank. I used a 1-1/4" long hardened drift pin to stick through this hole and peened the edge of the hole into the cross pin to hold it in place. Now for the fun part. To make the bends as perfect as possible I made a homemade forge. Take an old metal electrical box (8"x12") fill it about full of charcoal briquettes, a little lighter fluid to get it going and with the box on the ground I used a 2' section of metal downspout aimed right up to one of the large knockout holes in the side of the box. I placed an old hand held hair blow dryer at the other end of the downspout. crank up the hair dryer for the "wind" and watch them briquettes get hot real fast. Lay your round stock metal with the measurement for the bend marked with a file directly on top of the box and let it heat up and don't even attempt to pick up the rod unless you use tongs or some pliers. Bend it over in a good vise and proceed with the second bend after proper heating. Let the rod cool naturally to keep it's temper. (If you cool it with water you may end up with a crystalized crank that will either bend or snap on the first use). Of course if you have a heating torch, use it and don't bother reading the last 4 inches of text. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
