Farmall & IHC Tractors Discussion Board |
Re: Primer Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on November 21, 2006 at 14:42:35 from (204.249.178.135):
In Reply to: Re: Primer Question posted by GordoSD on November 21, 2006 at 09:43:56:
Sandblast the rim. If it still looks sound, you can use body filler or some two part putty to fill the pits. I sometimes use JB weld on areas I consider too deep for filler. It does not sand easily but it can be done. Dents in sheet metal can be lightly hammered (dollies, etc are best, I don't have any). Bring the dent to within 1/8-1/16 of the surface, use body filler, sand, repeat if necessary. I try to not to apply filler more than 1/16 inch thick, it is more or less permanent at that thickness and won't fall out. Use a single part putty over the filler to fill pinholes, etc in the filler, prime with epoxy primer followed by a sandable surfacer, repeat the surfacer if necessary, then topcoat. Done right the repair is invisible.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|