Farmall & IHC Tractors Discussion Board |
Re: Primer Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on November 20, 2006 at 20:03:18 from (204.249.178.135):
In Reply to: Primer Question posted by trw on November 20, 2006 at 19:44:43:
I don't use Case-IH 2150, if I did I would use epoxy primer on all, and a sandable surfacer or primer surfacer over the epoxy on the sheet metal to assure a smooth finish. Both of those products will cost more than the 2150 itself. But the Case-IH primer is ok. Epoxy adheres to the metal better and is waterproof, thus it gives corrosion protection. Both the epoxy and surfacer are likely compatible with 2150, I can't say for sure because I haven't actually done it. But, I would have no hesitation if I ever decide to use it. As to hardener, don't use it unless you have a supplied air system, a charcoal mask is not adequate protection. The isocyanates in the hardener can make you very sick.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|