Farmall & IHC Tractors Discussion Board |
Re: SMTA various rods?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on November 09, 2006 at 19:47:22 from (4.154.241.18):
In Reply to: SMTA various rods? posted by Atvman on November 09, 2006 at 18:19:17:
I wouldn't hesitate to make any of the rods you listed if I had a pattern to go by. I do, of course, so it is easy for me to say. I think Home Depot will have the stock. A propane or MAPP gas torch will give you enough heat to make accurate bends on the small diameter stock. The hydraulic rod will require a bit of welding. I think the small protrusion that locks the rod to the rear was attached with a resistance weld. It also needs a thread, a couple of nuts, and a flatbar clip bent to a 90 degree angle If this isn't something you wish to pursue, just keep watchng eBay. Those parts will come up. The choke rod is probably universal to all M's. The other two will need to come off a SM with live hydraulics.
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|