Farmall & IHC Tractors Discussion Board |
Re: Got A Little Problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Robhkent on November 09, 2006 at 19:14:51 from (209.131.239.251):
In Reply to: Re: Got A Little Problem posted by Allan In NE on November 09, 2006 at 17:39:40:
They work real well with a straight post. I cut some hedge post last year (relatively straight) they did not work... tended to bend to much. The regular creosote posts work well though. I did hit a rock with a 6 x 8 post last week. After two blows the post split about 1/2 way top to bottom. Using them all depends on ground conditions. Guys here in SW IA build a lot of fence that is 2 or 3 steel and then 1 wood. The wood post is ususally a 4.5" x 6" post with 6x8 cornerposts. Those 4.5 x 6 go in the ground in about 8-10 blows (on a normal day). The 6x8 I did last week took about 35-40 blows. Those post were all driven into the end rows of a corn field. The guy I was building for was expanding a corral. Rob
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|