Farmall & IHC Tractors Discussion Board |
Re: HHHHHHHHHEEEEEEEEELLLLLLLLLPPPPPP!!!!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Lunatic Fringe on November 03, 2006 at 11:18:34 from (63.218.43.2):
In Reply to: HHHHHHHHHEEEEEEEEELLLLLLLLLPPPPPP!!!!! posted by Farmall freak on November 02, 2006 at 16:13:26:
Make sure your linkages are not binding. If you have taken them off to work on the carb you have to make sure you reattach everything in such a way that nothing binds. You put everything back together but don't tighten the screws all the way at the carb, the governor, and the place in the middle where the adjustments are made. With the screws attached but loose, make sure the linkages are adjusted per the instructions, then you tighten the tubes at the carb first then the middle then at the governor. I think that is the correct order, I have a case of CRS so I'm not exactly sure. Its amazing what having the linkages correct will do to a surging governor.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|