Farmall & IHC Tractors Discussion Board |
Re: Converting a Super A to Rockford Clutch
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on November 03, 2006 at 01:47:56 from (216.208.58.157):
In Reply to: Converting a Super A to Rockford Clutch posted by City-Boy McCoy on November 02, 2006 at 18:12:04:
Mike: Just a matter of buying the Rockford replacement parts. I bought clutch disc, presure plate, release bearing and pilot bushing and had a young IH technician lived near by who did the work in his own shop. I don't think he encountered any problem with fork that activates release bearing. His billing was nothing but labor. He was the type that would cry for more money if he encountered extras. I will tell you what I encountered in buying those parts back in 1992. I told the CaseIH partsman, whom I had dealt with forever, I wanted Rockford clutch parts for my SA. He said, "Your in luck, we haven't stocked Auburn clutch parts for any tractor in over 25 years." That is now close to 40 years ago and I'll bet most CaseIH dealers did about the same.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|