Farmall & IHC Tractors Discussion Board |
Re: Rototiller, not H, 450?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on October 18, 2006 at 17:03:27 from (4.154.241.159):
In Reply to: Rototiller, not H, 450? posted by Trent M on October 18, 2006 at 16:17:11:
The TA will reduce you speed 30% There are alot of variables with tillers. Some are cheap and will break or wear out if stressed. Howard has always had a good reputation. Variables also include width of cut, overlaps of cut, depth of cut, soil type, sod or bare, previous tilling, moisture, rocks, and on and on. On the whole, a rugged 5 ft tiller run with a 450 in 1st gear low range should be OK. If not, till four inches and make another pass at 6-7". Or till new ground with half the tiller in the fluffed-up soil. I am sure you will figure something out. Go fo it. I till with a five foot Howard attached to a 660 equipped with a fast hitch. I don't have any problems. Never tried it with my fast hitch SMTAs or 400.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|