Farmall & IHC Tractors Discussion Board |
Re: Plow for a Super M ???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BillyinStoughton on October 18, 2006 at 11:42:58 from (69.214.162.13):
In Reply to: Plow for a Super M ??? posted by Newbie to this on October 18, 2006 at 09:38:23:
Your M should handle 3 bottoms without much of a problem. Here in Southern Wisconsin we've got some pretty rich stuff, and I can go all day with 3-16's and not really have a issue. I know a lot of guys on the board have said an M won't handle 3 bottoms, but I just can't fathom that...unless they are talking about working up straight clay or ground that hasn't been touched in two decades. There is no reason that a Farmall M in good tune and running order, shouldn't pull either 3-14's or 3-16's. Just my opinion. Billy
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|