Farmall & IHC Tractors Discussion Board |
Re: Cutting a flywheel Gauger janicholson
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill in OH on October 17, 2006 at 18:13:25 from (71.79.44.154):
In Reply to: Re: Cutting a flywheel Gauger posted by Janicholson on October 17, 2006 at 12:28:14:
That was supposed to be 0.048 0.060 I suspect you are one of them guys that notice everones mistakes over than yours. i suspect you are one that knows whats wrong with it how much it cost whats size tools i need and how long it takes& jack down the said you have to take the left rear inside dual off leave the out side one on to put the number 3 cam shaft baering in???? Now do you want to FU-- with putting the cluch back in the 1486???????? you know i made a mistake on the 1066 1486 flywheel thats a hep a loy of wheel to make a FU--ING mistake like that on 800 bucks for a new one HE-- of a mistake?
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|