Farmall & IHC Tractors Discussion Board |
140 Governor question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by E. Ray Heflin on October 16, 2006 at 09:12:20 from (72.147.26.155):
Hey guys.......I posted a ? about the governor on a 140 Farmall on 10/9/06. I am helping a friend with his. We order a T&I shop manual (IH-201) and on page 21, the thrust pin appears to be inserted into the housing. The reason I say this is there is only one part shown here. When we took it apart, the pin appeared to be broken. I just got a new one delivered here at work and now I am wondering if it is supposed to be inserted into the housing or just rides againist another pin that is inserted into the housing. We did find a broken surge spring and decided to replace the governor spring and thrust spring while we had it apart. If someone can help us with thrust pin queston, we would be most appreciative.........thanks.........E. Ray
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|