Farmall & IHC Tractors Discussion Board |
Re: Remove Steering clutch Internatinal TD6
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by shark on October 13, 2006 at 19:17:45 from (209.103.228.231):
In Reply to: Remove Steering clutch Internatinal TD6 posted by Gadi Silberstein on October 13, 2006 at 09:56:59:
I worked on a td 6e,and to remove the clutchs without totally disassemble can be done. The td6 e had a cover on the side of the final drive.I believe you will need to drop the track on one side and remove the spocket gear. behind that is a small cover the u can remove the bull shaft, and eventally slide the shaft thru this hole to get the cluches out. I didn't give you alll the detail s but everything will come to you.I can double my book if you have any other questions good luck ...shark
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|