Farmall & IHC Tractors Discussion Board |
Re: Broken Seat Spring.. Fact or Fiction?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on October 12, 2006 at 05:39:52 from (64.80.108.52):
In Reply to: Broken Seat Spring.. Fact or Fiction? posted by 772TAS on October 11, 2006 at 20:11:24:
First, if you're brush hogging in an unknown area like that, SLOW DOWN! These tractors are not dune buggies, and the wheels should NEVER leave the ground. The frames of these tractors are not meant to take large shock loads like that, and even a short hop can cause the tractor to break in half in the torque tube area, or the front end to snap off. Second, a dead man switch won't save you if you fall off the seat. The mower and tractor have enough momentum that you'll be in pieces six feet behind the mower before the tractor even thinks of slowing down. Third, if you fall off the seat because of a broken seat spring, what are you doing with your hands? You need a firm grip on the steering wheel with at least one hand at all times just to keep the tractor under control. If/when the seat spring breaks, the worst thing that should happen is your butt drops a few inches.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|