Farmall & IHC Tractors Discussion Board |
Re: Duals for an h?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dr.EVIL on October 09, 2006 at 09:35:53 from (80.254.152.36):
In Reply to: Re: Duals for an h? posted by Chuck46 on October 08, 2006 at 20:14:32:
The old H & M wheels proved to be kinda weak when clamp-on duals were used because of the off-set forces from the dual wheel being so far away from where the hub clamped to the axle. The cast wheel centers would crack across the corners on the "D" shaped hole. Since the same basic wheel was used up to the 460/560 models and even later on up to the 686 & Hydro 86 I wouldn't recommend using clamp-on duals for heavy tillage. (What ELSE would You want duals for right? ;-) That being said Dad ran clamp-on duals on My Super H and his M for planting corn and other lighter duty jobs but the plowing & discing was done with bolt-on duals.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|