Farmall & IHC Tractors Discussion Board |
Re: Janicholson! Posting help.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on October 09, 2006 at 06:38:00 from (199.17.6.122):
In Reply to: Janicholson! Posting help. posted by GA Dave on October 08, 2006 at 21:10:53:
The advice received below is good. Good digital images require mega pixels, and most posted here (including mine) are much less. So the picture needs to include only the important material. If it is a image of plowing in Nebraska, it should show the landscape. If it is a picture of a broken bolt, it should not, thus taking the image is the first step. Most cameras I am familiar with have several settings (just like a Farmall reading the manual is key) that adjust pixel count, or purpose. Setting the "quality" of the image to Web publishing", or 640X480, or Low resolution, or 600-800K file size, will set the image to the usable size to begin with. Placing the Photo in the appropriate gallery to the left on this site will usually automatically resize a reasonable picture. For high resolution, the most common way is to direct Email the person needing the image. Even then they may have file size restrictions on their inbox. Ask first! Sending a CD in the mail is the assured method of sending great high res material. A well focused and stable image of 1.5mb in jpg format will make a reasonable 8X10 print. I use about 25mb on my poster size prints and an 8 megapixel camera. When resizing larger or smaller two rules persist: It will be imposible to add detail by increasing the pixel count on a image that exists. AND It will degrade the image to reduce its pixel count. These may not make a visible difference if the image is printed on small paper, but ifd enlarged, they sure do. Good luck, Jimn
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|