Farmall & IHC Tractors Discussion Board |
Re: 130 underway
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on October 05, 2006 at 18:37:56 from (209.226.106.188):
In Reply to: Re: 130 underway posted by Hobo,NC on October 04, 2006 at 04:44:48:
Hobo: The reason IH didn't put grease fitting in those holes, is folks would grease then too much. It calls for grease after 500 hours or 6 months. the manual suggests you install fittings and remove them after greasing. I expect a one man show could get by with full time fittings. It originally called for regular gun grease, and I expect in NC that will work well. Years ago an IH technician reconended white automotive grease in our colder climate. They had some trouble with regular grease in -20F to -50F weather. Ed ocasionally gets the latter. He starts an out door skating rink for kids mid Nov. and they skate on it until April. I just buy squeeze tubes of the white grease, and squeeze it in the holes. It's not worth my while keeping a grease gun for white automotive grease. I expect Moly grease would work well also.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|