Farmall & IHC Tractors Discussion Board |
Front End Swap???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by steve in sc on September 27, 2006 at 16:48:35 from (216.218.125.155):
I've been poking around the internet to find out if a power steering setup from a 2444 will swap out with a non power set up on a 424. From what I can tell, it looks very similar but they're across the county from each other so it's tough to do a side by side comparison. The 424 is SN-01776 and the 2444 is SN-06038D. I don't know if that helps or not. It seems that the steering column and valve under the gas tank will have to move over to the 424... Other than that, it looks like it will all just bolt up under the nose of the 424 but I'm not sure. I'd rather get some expert opinions before spending the money and having parts pulled and sent to me to find out they won't fit. Thanks in advance for your time, steve in sc
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|