Farmall & IHC Tractors Discussion Board |
Re: How to remove a inner brake plate / bearing re
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by D Slater on September 25, 2006 at 08:54:32 from (152.163.100.65):
In Reply to: How to remove a inner brake plate / bearing retain posted by ENJ62 on September 25, 2006 at 07:47:57:
Plate is around 1/2 inch wide on outer edge,look for a parting line and some notches to get a pry started. Or screw a slide hammer in threaded hole in end of pinion shaft and they will both come out togeather. They are hard to get started out sometimes, When you get retainer out its no problem to remove seal. Retainer uses a O Ring to seal outside. If its a Super with disc brakes it comes out from outside.If its the bull pinion and differential carrier housing that needs removed the bull gear inside housing has to be moved out of way first.
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|