Farmall & IHC Tractors Discussion Board |
15-30 Cylinder Sleeve Packing Ring
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John Simms on September 22, 2006 at 15:49:14 from (198.88.237.147):
My father in-law is starting to restore a 1929(?) McCormick Deering model 15-30 Gear Drive Tractor. He is in need of the packing seals (actually square-cut O-rings) which provide the water seal between the cylinder sleeves and engine block. Per the instruction book that came with the tractor, the IHC part number is 4222D. The cylinder bore is 4.75" and stroke is 6 inches. I measured the diameter, width and depth of the packing groove in the block and tried to substitute some regular modern day, circular cross section O-rings. They either weren't quite the correct size or they were cut sliding the sleeve in place. Either way, they leaked so had to re-pull the sleeves. I'm sure someone else has had the same problem. So, I'm looking for either original, square cut, direct replacements packing glands or the correct dash size for modern, circular cross-section O-rings that can be substituted. If anyone has any information or words of wisdom, it would be greatly appreciated. Thanks in advance. John Simms Edwardsville, IL PH 618-692-1799 Bud Muhs, Noble, IL
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|