Farmall & IHC Tractors Discussion Board |
Re: Forgot the pics =P
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on September 17, 2006 at 16:08:09 from (4.154.243.228):
In Reply to: Re: Forgot the pics =P posted by Nebraska Cowman on September 17, 2006 at 15:36:05:
I agree with Cowman. Drill and tap and get on with your life. So you drill into the shaft. No big deal. However, if that doesn't appeal to you, use some of your welding equipment. It doesn't sound like you have oxy-acet torch. That would certainly do the job. Forget the ice cubes. But you do have a carbon arc. Does that include an air-arc? Slice thru the top of the arm down to the splines. Drive a thin wedge in the kerf and the arm will slide off. Repair the arm with weld and grind. Nobody will know the difference particularly if the cut is on the bottom. I use rock spliting wedges because they have a gentle taper. An old screwdriver would also work. Drive it parallel to shaft.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|