Farmall & IHC Tractors Discussion Board |
Sleeve kit
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Howard H. on September 16, 2006 at 19:45:33 from (65.197.86.8):
Hi All - I found 2 sets of new old stock IH sleeves/pistons at a sale today. The estate had 8 22-36 McCormick Deerings (and nothing else), so I"m pretty sure that is what they fit. I have a couple of 10-20"s - I was just wondering if they would fit that engine, too - or just the 22-36?? Would they also fit a 15-30? Also, the pistons are in the cylinder sleeves in the box - they seem pretty stuck - just from the old grease - there is no rust on them - but would they have shipped like that from the factory with the rings in them?? If so, do you just push the piston down until you can slide the wrist pin out and put the connecting rods on?? Thanks for any advice, Howard H.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|