Farmall & IHC Tractors Discussion Board |
Re: TracTractors PTO
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on September 11, 2006 at 02:46:27 from (216.208.58.185):
In Reply to: TracTractors PTO posted by Dave H (MI) on September 09, 2006 at 19:48:10:
Dave: I'm surprised you don't have an answer to this. Must have been some folks away from their computers over the weekend. I saw this when you first posted, don't have your answer. I'm thinking they are very similar to most old IH transmission driven PTO's, in that it can all be done from back of tractor. I'd pull the PTO from the parts tractor, if the long shaft going to transmission comes with it, take a light, look in, I think you will see a spline in end of transmission shaft, that matches shaft you just pulled out. On the tractor your going to install this on, park it on a 30% down grade, you can remove that back cover without any loss of rearend oil. You should be able to see if they are the same. I'm betting you can slide your doner unit in, bolt it up and go. I am asuming IH used the same engineering principles on these as on the big standard wheel tractors. I may not be right, but I know you will be able to tell what your getting into without taking more than that back cover off. Transmission driven PTO's are all driven off the transmission shaft that goes directly to the clutch.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|