Farmall & IHC Tractors Discussion Board |
Re: Tank Heater Placement On 806D
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on September 09, 2006 at 01:41:02 from (216.208.58.184):
In Reply to: Re: Tank Heater Placement On 806D posted by Harlen Larson on September 08, 2006 at 20:59:22:
Harlen: I had a feeling block drain was on opposite side on 806. I was very lucky, my engines all had block drain directly below the port on the head. The circulating heaters I had were cylinder shaped, about 7-8" long and 3" in diameter. I found they worked best if you could position them upright so discharge was directly above the inlet. That free flow of hot coolant going up and return coming to the bottom of heater is quite important. I your case I'd be tempted to mount the heater just below the port on the head, then run the hose from the block drain under the engine. I'd be afraid of the hose on top of clutch housing lying too flat. Basically what your trying to do here is run a hot water heating system without a circulating pump. Techincally it's very similar to thermosyphon in the Super A. The better you can make flow, the more effective it will be.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|