Farmall & IHC Tractors Discussion Board |
Oil Pressure Results
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BOBCD on September 08, 2006 at 17:43:58 from (67.140.20.121):
I mounted an oil pressure gauge 100 psi as you guys suggested. The tractor is 1950 SA. At start up it held 35 psi for about 30-45 min and slowly drop pressure, when the tractor was hot under load cutting heavy grass in 1 st gear at about mid throttle, she stayed at 13-18 psi for the next 3-4 hours. I'm wondering if this tractor is ready for an overhaul or is that an ok range and if I can hold off for awhile? I will do a compression test next.I run 30 wt. non-detergent per manual and change every 50 hrs. So is this a normal range? Thanks, Bob
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|