Farmall & IHC Tractors Discussion Board |
How to check condition of the rear end.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on September 07, 2006 at 06:18:09 from (24.223.138.48):
Hi guys, What the best way to check the condition of the gears in my rear end? I really dont want to remove the top of the rearend, as i would need to remove the hydraulic rsevoir, which would involve removing the hydraulic hard lines to the pump. and somehow getting 2 of the bolts removed that are stuck (ugh!!) The less I have to mess with potential leak probems, the better. Now my 300u has no pto, so I was wondering if i could remove the cover plate and look in there. How High does the oil actually fill? does it go higher then this cover? would i need to buy a new gasket for the pto cover? There is no visible leaks when i took the homemade toolbox off the top 2 cover bolts. Any tips would be appreciated. I keep hearing of hytran fluids, does anyone sell compliant fluids besides the case dealer? TSC has nothing and neither does the hardware store. Thanks guys.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|