Farmall & IHC Tractors Discussion Board |
Re: Need Help on New Idea Loader
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hermit on September 06, 2006 at 20:16:48 from (69.21.48.92):
In Reply to: Need Help on New Idea Loader posted by Triker on September 06, 2006 at 12:42:22:
I have the same loader on my M. The actuators are ram type actuators. There are 2 'O' ring seals in the large gland nut that screws into the top of the actuator. The set screw is just there to bleed the actuators and needs to be installed-no breather. Hydraulic fluid under pressure goes in the bottom of the actuator when you move the control rod to lift the bucket, filling the cylinder and forcing the ram upward carrying the bucket with the rams. The weight of the bucket lowers it. Mine is set up with the hydraulic hose coming off the left front outlet port, then tees off into two hoses, one to the bottom of each actuator. That way they will lift at the same time. If the belly pump on your H holds the same quantity fluid as an M (I'm not sure), there's enough fluid to lift the bucket to the top of the actuators without air getting into the system and causing a spongy effect. Have fun.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|