Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: F12 can't get 'er to start fer nothin'


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by KEB on September 05, 2006 at 21:26:46 from (207.94.27.4):

In Reply to: F12 can't get 'er to start fer nothin' posted by holt_2ton on September 05, 2006 at 16:19:47:

Start with the basics. Engines need compression, fuel/air in the right proportions, and spark at the right time to run. My regular started this spring on the 2nd pull after sitting all winter, & the only time I've ever had trouble getting it to start was when the magneto had gotten wet. One pull with it choked then one or two pulls with 1/2 choke almost always starts it.

If you're hand cranking, you should be able to feel the cylinder come up on compression. Bring the engine around to where you feel it start to come up on compression, then quickly pull it through compression. You should be able to feel the difference if one cylinder has low compression from a stuck valve.

Check the timing and the impluse on the magneto. The impulse should trip just after top dead center (it'll kick back if the magneto trips too soon). It'll be hard to start if the impulse is tripping too late. How did you verify a good spark? Make sure you don't have flakey spark plug wires (and no resistor type spark plug wires).

If its still not running, that only leaves fuel. If its flooded you should be able to smell the gas fumes coming out of the exhaust, although I'm not sure how you could get it flooded in a couple pulls on the crank. Have you tried priming it with a little gas squirted in the air intake instead of choking it? A lot of aerosol carburetor cleaners are mostly propane (amazing what you learn by reading the label), and in my experience make good starting fluid for a gas engine. Propane isn't nearly as hard on an engine as ether. BE CAREFUL, TRY THIS AT YOUR OWN RISK, PROPANE IS EXTREMELY FLAMABLE. Instead of choking it, squirt a little carb cleaner in the carburetor air inlet & give it a couple pulls. If if fires, you have a fuel problem.

Good luck,

Keith



Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy