Farmall & IHC Tractors Discussion Board |
Re: getting at Super A brakes
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by banjo on September 05, 2006 at 09:09:00 from (65.67.203.174):
In Reply to: getting at Super A brakes posted by Pa. Pete on September 05, 2006 at 07:58:41:
Please be careful first and I hope i remember correctly. I;m sure someone will remember what i have forgot. The final drives are Heavy as a assembly. The right wheel is cast and HEAVY, probably 150# or so.Also the diff shaft is long so you need plenty of room for the entire shaft to come out when the houseings are loose. The brake drum is on the shaft with a set screw and woodruff key. sometimes the are stubborn. wedge the front of the tractor just to be safe to keep it from moveing. Do one side at a time.I do not know how strong you are as to the weight you can lift. You can support the final with a floor jack but remember the bottom is round and will be unstable.Cherry picker may be more stable with less chance of falling. I think i used the floor jack method. If it has the outer wheel weight then yes remove it first. , but remember the right wheel is just as heavy as the weight. The cast wheel is for the counterbalance. Mine has weight on both sides for traction. All the peices are over 100# . You could probably do the brakes without removing the final drives completely if you have to support for the final drives. I had to replace seals also. If i'm wrong someone please correct me.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|