Farmall & IHC Tractors Discussion Board |
NOS Pistons
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by One other IHC ? regarding on August 31, 2006 at 12:39:15 from (70.182.249.70):
I may have asked this question already, but at any rate I still don't have an answer, so I'll try again. I have a set of NOS sleeves and pistons for an IHC. Possibly a F12, but not sure. I posted a picture in the help identify if anyone would like to see them. The pistons are 3" dia, the overall height of the sleeves are 6 7/8". The bottom 3 3/16" of the sleeves are machined, and above that is rough. There is a lip around the top of the sleeves. The part #'s I see are inside the pistons. B12, 30A, N3, and the IHC emblem. The ends of the wrist pins have X8N on them. Would any body know what they fit? Thanks in advance - Bob
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|