Farmall Tractors Discussion Board |
Re: Tractor pullers
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Les Repair on January 24, 2000 at 18:22:36 from (206.28.174.159):
In Reply to: Tractor pullers posted by Steve on January 23, 2000 at 14:11:39:
I built a big M motor for antique pulling several years back. Our club ran stock RPM so it seems you can get by doing things that the experts say won"t work. I would say if you are going for cubic inches, I would go for a larger bore than 4 inches. M&W makes a 4 1/4 inch kit for their long stroke crank. I used Case 830 diesel pistons which are 4 3/8 and ran them in a 450 block without sleeves and didn"t strike water. If you want to run a stock M or 450 piston with a long stroke crank, you can cut the connecting rod close to the piston pin and remove a section of the rod and weld the rod back together. I have seen it done and it works. Give me a call 515 847 2731.
Follow Ups:
Home
| Forums
Today's Featured Article -
Chores - by Frank Young. The ceaseless passing of time! It is at once our friend and our enemy. It measures our progress and it makes us old. Like most features of our life, few things are all good or all bad, and most such judgments depend on our own perspective or viewpoint. In our particular hobby, we enjoy the nostalgic return to the days of our youth as we recreate many of the scenes that took place on the family farm that served as the stage for the first few acts of the play that is our live
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|