Farmall & IHC Tractors Discussion Board |
Re: 560 LPTO AND HYDRO PUMP SPEED
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on August 21, 2006 at 12:59:34 from (4.154.246.174):
In Reply to: 560 LPTO AND HYDRO PUMP SPEED posted by vance stanton on August 21, 2006 at 10:59:21:
There are four gears: SMTA/400/450 with planetary PTO .... 47 teeth 560 with planetary PTO .... 51 teeth 660 with planetary PTO .... 55 teeth 560 with clutch type PTO .... 70 teeth These are the driven gear on the front PTO shaft. You will also have to change the driving gear up by the flywheel. Seems like you need the gear set out of the SMTA etc. Seems like they would interchange but I won't gaurantee it. You need to take care that the gear bore is good. I have seen bad holes and it causes the gear to wobble. Prolly screws up the nearby roller bearing as well. .
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|