Farmall & IHC Tractors Discussion Board |
Re: Balanced head mower
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Steven@AZ on August 11, 2006 at 17:19:14 from (24.121.155.253):
In Reply to: Balanced head mower posted by Danny H2 on August 11, 2006 at 08:33:12:
Which zerk are you talking about?? The head pin that moves back and forth can be greased as much as you want. I try to grease mine every hour, as there is no seal on it to hold the grease in it. As for the internal grease zerks inside the actual mechanism (mine has 2 plugs, each has a zerk behind it) one on top and one in the front. Those are to be greased about 4 to 5 shots every 100 hours. Overgreasing the internal bearings will destroy them. Same deal with the rear zerk on the balanced head. Pivot points can be greased as much as you want. I have a manual for my 1110, if you email me I can run off some copies of the pertinent information and mail it to ya!
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|