Farmall & IHC Tractors Discussion Board |
Re: Back at Farmall exhaust pieces.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Steve Crum on July 30, 2006 at 13:55:43 from (4.156.228.6):
In Reply to: Re: Back at Farmall exhaust pieces. posted by Paul G. in Mn on July 30, 2006 at 08:35:45:
I had to dig back into some old records, the first one of these I built was in January 1995 for a Farmall M and I sold it for $135.00. At that time 6" 14 ga 304 stainless tubing cost me $8.23 per foot. The last 6" I bought was $32.53 per foot for 16 ga if I bought it in 40' increments. I've been told there have been 2 price increases since the first of June. The mufflers pictured are $165.00 plus shipping My price has only increased 22% in the face of my cost for most stainless increasing an average of 277% The stainless 6" has increased 395%. I may in the future be forced to look off shore for tubing. I'm about efficencied out here in the shop.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|