Farmall & IHC Tractors Discussion Board |
Re: 4th and 5th slider
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on July 29, 2006 at 08:04:24 from (66.173.50.172):
In Reply to: 4th and 5th slider posted by H fanatic on July 28, 2006 at 17:44:30:
A teacher of mine (who was an indy race mechanic) explained to me that, using a shaft tool with a diamond tip, the teeth on a gear engagement dogs (drive and driven)could be polished to be undercut so that they were interlocked when in gear. He said (and I believe from having done it successfully) it is a small amount removed from the drive sides of the splines tapering .001 deeper at the full extent of engagement, and nothing at the beginning where they are rounded from wear. If you have a junk gear to practice on, it might be a way to save a marginal gear or slider set. Also discussed was the importance of good intermediate bearings and front main bearings that maintain a correct alignment and prevent walking of the splines out of mesh. Just some thoughts. (the trans I made work was high gear in an old chev three speed column shift trans) JimN
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|