Farmall & IHC Tractors Discussion Board |
Re: Tinwork Tip
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jaybird2 on July 26, 2006 at 08:23:59 from (66.41.212.16):
In Reply to: Re: Tinwork Tip posted by GordoSD on July 25, 2006 at 11:28:25:
Thanks Gordo, I'm getting better with the body hammers and dollies. It's been very satisfying to see a grill that was literally bent in half, come back to shape (especially when you see them go for $280.00 on an ebay auction!) It's really amazing to see how such little pressure is needed to make the small changes in this sheet metal and how fast you can make the situation worse if you're not careful. Takes some time to figure out exacty what you need to do (dolly v off dolly v. inside v. outside etc). Someday I'll post the results and before/after pictures. - Jay in MN
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|