Farmall & IHC Tractors Discussion Board |
casting dates
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by farmall wrangler on July 23, 2006 at 07:24:54 from (64.12.116.65):
I saw a post recently about casting dates versus serial numbers. I believe the conversation was about a cub. I have a little different situation that I am curious about and am looking to all the knowledge on here for thier ideas. I am currently restoring a MD that by the serial numder (FDBK285487) is a 1951. As I was disassembling and paint stripping I found that a lot of the casting dates were for early 1952. Examples Steering bolster 1-21-X Transmission/Rear 1-15-X Left axle housing 1-8-X Right axle housing 1-22-X Belly pump 1-11-X The only parts that show the 51 dates are the engine (11-12-W)and the Bell housing 8-30-W. Also cast on the lower housing of the front end is the word "Belectromal" I have not ever seen any reference or conversation about this? Sorry for the long post just trying to get some good sunday morning conversation started. Thanks for any information and I hope to have pictures to post as soon as I complete the restoration.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|