Farmall & IHC Tractors Discussion Board |
60-70 psi oil pressure?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by markloff on July 18, 2006 at 19:05:57 from (70.41.89.71):
Hello, Why the heck did the WD9's have such high pressure? My manual says 60-70 psi is normal. My 560 only runs at about 35-45 psi. Also most modern diesels I've been around, namely my 444E in my IH truck, only run about 35-45 psi. What gives. Why such high oil pressure on an old low rpm motor? IH must have installed a different guage in these old beasts too. Does anyone know if the correct guage is 41934-DC? I think the one used in the M's and H's is 41934-DB. I'm talking about the style with the small red band on the left hand side and no increments or numbers on it. The two guages look the same but have different letters at the end of the part number. The guages read differently, I tested them to a numbered guage. Thanks in advance, Mark
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|