Farmall & IHC Tractors Discussion Board |
Re: Super C Front Hub Conversion
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on July 17, 2006 at 16:49:05 from (209.226.106.96):
In Reply to: Super C Front Hub Conversion posted by Stiles on July 17, 2006 at 11:36:21:
Stiles: You can go to most any reputable bearing shop with you old hub and he can match up your axle with a hub that can be ordered to suit a particular wheel. You can probably take most any car hub to him that has roughly same dimensions as your SC hub, and he'll be able to fix you up with bearing and seals. Now, for half the money, you can call Miller Tire, he will fix up with a new set of Super C front rims right to factory specs. Your old rims are rotten. You take the new rims, install new tires, put in 30-35 lbs air, bolt rims tightly to hubs and I'll guarentee you, "You are not man enough or rugged enough to stay with the SC long enough to bend rims. You will break bones and front end off tractor before you bend new rims.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|