Farmall & IHC Tractors Discussion Board |
Re: IH 2000 loader on a farmall 460, will it fit?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Weldon K on July 17, 2006 at 07:30:57 from (71.28.78.138):
In Reply to: Re: IH 2000 loader on a farmall 460, will it fit? posted by Isaac Mempa on July 16, 2006 at 16:53:16:
If you have capability to fabricate necessary brackets it would not be difficult. You would need a pattern and measurements to go by. Modifying the subframe to fit the rear axle may require lengthening it by adding necessary length of 4x4 tubing. The butt plate which rests against the axle housing might need to be reworked (change shape of it, drill new holes ). The front mounting brackets could be fairly simply constructed with steel plate and angle . If you want, I can send you pages from Operator's manual showing drawings of mounts for various tractors. I have a 2000 loader on a F-856 and a 2001 on a I-504 and can make photos of brackets . The 856 front brackets are built of two separate parts, bolted together, to make a right side assembly and then another assembly for the left side. Brackets needed for a 460 are very similar to these. Rear mounting on the 504 is the same as needed on 460.With pages from manual ,photos and measurements that I can give you ,you could make them yourself or have them built . Reply here if interested. Weldon
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|