Farmall & IHC Tractors Discussion Board |
International 404 Carb
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 806 Southern In on July 16, 2006 at 12:59:04 from (70.223.108.82):
Recently bought a one owner 1400 hour 404 that is very straight and original. Perfect for a restoration. Has some leaks that will need addressed but currently am dealing with a carb problem. The tractor sat for about 3 years and so the tank and carb were varished up. Got the gas tank and fuel line cleaned up but am having problems with the carb. I took the carb apart(marvel screibler sp?) and cleaned out all the ports and needle valve with carb cleaner. Everything seems to move freely. But when I start the tractor up it will run for about a minute and then die. After a little cranking the engine will start and run again but then will die. I have even plumbed a seperate fuel tank to the carb to see if I was getting enough gas into the bowl and that didnot fix the problem. I checked the spark as the engine dies and the plugs are still firing so I don't think its spark relate either. One note, if I let the gas on overnight the clean air side of the carb has gas in it the next morning?? Needle valve not sealing? Well I'm stumped, if anyone has any ideas I'd sure appreciate them. I have not yet put a complete carb kit in it, $110 so I'm waiting to make sure that's the route I have to go. Andy
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|