Farmall & IHC Tractors Discussion Board |
Re: Super A Right Angle PTO
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jim Becker on July 13, 2006 at 05:46:36 from (71.96.3.174):
In Reply to: Super A Right Angle PTO posted by City-Boy McCoy on July 13, 2006 at 04:51:18:
Serial break for the change on the A was 66671. As far as I know, anything after that through 140 will be essentially the same. Beware that entire PTOs may have been moved between tractors so look for pulley drive housing 9090D. You can't just slap the attachemnt on. Bevel gear mesh is set with shims. It may be easiest to just change an entire pulley and PTO attachment from another tractor. If you get an entire unit from an A, you need to reuse your current PTO shifter (the hollow tube that slides on the drive shaft).
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|