Farmall & IHC Tractors Discussion Board |
Re: Saginaw 3pt ???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on July 12, 2006 at 05:29:23 from (204.249.178.138):
In Reply to: Re: Saginaw 3pt ??? posted by Hugh MacKay on July 11, 2006 at 20:43:31:
The spool valve came from Saginaw, I don't know the brand, it's just a spool valve like those from any farm store, far as I know. And, I have always wondered why IH put the rear rockshaft on the fenders. About any other setup would be better. I never considered Worksaver after I found out about Saginaw. I haven't paid much attention to the cylinder (Cross?). As with most things with Saginaw I imagine it is larger than absolutely necessary. The C 3-point has 1 cylinder, the H-450 3-point 2. Actually the C 3 point is plenty heavy for the H, arms my be a different length, but it, also, is a good heavy duty hitch.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|