Farmall & IHC Tractors Discussion Board |
403 Combine gas into a tired 460D
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by GaryinMozarks on July 09, 2006 at 17:14:45 from (64.240.21.144):
Anyone out here willing to enlighten me on putting a 403 gas combine engine (C-263) in a 460d? I checked the old forum some but havn't gone through the entire list. Seems like I read that you have to switch the front plate becasue of a hydralic pump or something? will the one on the diesel work on the gas engine or do you have to find a front plate off a gas tractor engine? Are the flywheels the same or will the diesel flywheel fit on the gas engine? Is the combine engine sleeved or is that a non sleeved engine? You guys have always been super about dumb questions Thanks in advance.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|