Farmall & IHC Tractors Discussion Board |
Re: Int 664 Starting
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by wolfman on July 07, 2006 at 19:47:18 from (207.255.114.248):
In Reply to: Re: Int 664 Starting posted by K.B.-826 on July 07, 2006 at 18:57:22:
Thanks KB for the info. The 664 is basically a 656 Utility but with the 239 German Diesel. It has 4 of the same cylinders that an 826 has 6 of. I have an 826 and it has the advance feature like the 664. I've been (for years) starting both of these tractors by cranking them over about a second or two and then pulling the advance-about like you'd choke a gas motor. I'll try setting the advance first. Perhaps I've not set the throttle up enough. Thanks again for the good advice. By the way, by your handle KB-826, I figure you have an 826. I've said for years that in the history of man, no one will ever design a more user friendly tractor than the 826.
Replies:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|