Farmall & IHC Tractors Discussion Board |
Re: IH 1466 Hydraulics
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on July 05, 2006 at 08:46:59 from (64.179.117.181):
In Reply to: IH 1466 Hydraulics posted by Brian T from OH on July 04, 2006 at 21:48:11:
Change your ends on the hyd. cyl. They do go bad and this will cause this to happen . Went thru this this spring on the disk and corn planter . It would raise it but if you went to drop it it would start down and just stop then you would have to raise it up and try to let it down slowly if you went to fast it would lock up again . Last year it was the plow that was doing the same thing And like Allen said tighten up the drag on the draft control lever it is and easy fix , But the adjusting bolt MAY be rusted tight and THEY will break off and then that is a real pain in the donkey . Myself i like to remove the bolt and clean out the threads with a tap and install a new bolt with never seeze on it for ease of later adjustments.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|