Farmall & IHC Tractors Discussion Board |
Re: 966 Slow Hydraulics and 3 Point UPDATE!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K.B.-826 on June 23, 2006 at 20:35:27 from (24.180.143.24):
In Reply to: 966 Slow Hydraulics and 3 Point UPDATE!! posted by Erik in WI on June 23, 2006 at 19:36:32:
Have you replaced the relief valve? Filter new? You could have an internal leak. Remove the top link bracket, start the engine, and see if there"s a large amount of oil spraying down from the rockshaft housing. If you do decide to pull the pump yourself, here"s a tip for reinstalling it- there"s a short tube between the pump and the filter housing. Leave it out, install the pump, and then install the tube into the pump through the filter housing. If you try to install the tube with the pump, you run a good risk of damaging the seal that seals off the filter housing from the transmission case, which will possibly cause an air leak, and will definetly cause a huge oil leak the next time you remove the filter cover.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|